Models 24012 (E, W, EW, XL, LR, AR)
Installation, Operation and Maintenance
File: 24107
9
Rev. 01.09.01
2. Release the safety latch by pulling down on the latch until the cam sets to hold
this position.
3. Lower the lift by depressing the lowering valve handle on the power unit.
IMPORTANT
DO NOT WORK OR WALK UNDER THE LIFT WHEN THE SAFETY LATCH
IS IN THE RELEASE POSITION. IF IT IS NECESSARY TO RETURN UNDER
THE VEHICLE, RESET THE LEVER BY LOWERING THE LIFT SLIGHTLY,
THEN RAISING IT AGAIN. VERIFY THAT THE SAFETY LATCH LOCK PIN
IS ENGAGED IN THE LATCH RACK.
IMPORTANT
THE SAFETY LATCH WILL AUTOMATICALLY RESET WHEN THE LIFT IS
RAISED OF THE GROUND. ALWAYS VERIFY THAT THE LATCH IS
OPERATING WHEN THE LIFT IS BEING USED. CORRECT ANY PROBLEM
BEFORE USING THE LIFT.
Maintenance:
The following maintenance points are suggested as the basis of a preventive
maintenance program. The actual maintenance program should be tailored to the
installation site.
Daily
Inspect the lift for loose anchor bolts (if loose tighten to 70-80 ft-lbs), fluid leaks and
loose connections.
ALL ANCHOR BOLTS SHOULD TAKE FULL TORQUE
Weekly
Check fluid level in the power unit reservoir.
Monthly
Check cross rail and lift chains for wear and tension, adjust if necessary. Lubricate
chain with light oil to reduce drag.
To Next Page