To Next PageTo Next PageWhat does Exit Loop Error mean on my Chamberlain LA400DCS Gate Opener?
If your Chamberlain Gate Opener displays an Exit Loop Error, it indicates a failure or missing loop. This applies only to LiftMaster Plug-in Loop Detectors. Check the loop wiring throughout the connection for shorts or open connections. There may be a short in the loop, or an open connection.
What causes RPM / STALL Reversal (Operator 1) in Chamberlain Gate Opener and how to fix it?
If your Chamberlain Gate Opener shows an RPM/STALL Reversal, start by checking for any obstructions. If none are found, inspect the operator wiring and ensure the mechanical assembly is engaged and moves freely. If problems persist, consider replacing the APE assembly.
What to do if my Chamberlain LA400DCS shows Max-Run-Time Exceeded Error?
If your Chamberlain Gate Opener displays a Max-Run-Time Exceeded Error, check for any obstructions that may be preventing the gate from moving freely. After ensuring there are no obstructions, reprogram the limits.
What to do if my Chamberlain LA400DCS Gate Opener displays Product ID Error?
If your Chamberlain Gate Opener shows a Product ID Error, and you've recently replaced the control board, erase the existing limits, enter limit setup mode, and set the limits again. If the control board hasn't been replaced, disconnect power, wait 15 seconds, and reconnect power before changing the product ID harness.
What to do if my Chamberlain Gate Opener shows 'No battery at boot up'?
If your Chamberlain Gate Opener indicates no battery at boot up, check the battery connections and ensure proper installation. Replace the batteries if they are depleted to less than 20V on a 24V system or less than 10V on a 12V system. Ensure you are not using a single 12V battery on a 24V system.
Why does my Chamberlain LA400DCS Gate Opener show battery overvoltage and how to fix it?
If your Chamberlain Gate Opener reports a battery overvoltage, it means there is too much voltage on the battery. Check the harness and ensure that you are not using a 24V battery on a 12V system.
What to do if Linear Drive Disengaged (Arm 1) on my Chamberlain LA400DCS?
If the Linear Drive is disengaged on Arm 1 of your Chamberlain Gate Opener, disengage and then re-engage the arm. Also, check the wiring and connections to ensure they are secure.
Why does my Chamberlain LA400DCS say 'CLOSE EYE/INTERRUPT held more than 3 minutes' on expansion board?
If your Chamberlain Gate Opener indicates that the CLOSE EYE/INTERRUPT has been held for more than 3 minutes, check the wired input on the expansion board for proper alignment and any obstructions.
What causes 'Close input (EYE/EDGE) communication fault from other operator' on my Chamberlain LA400DCS Gate Opener?
If your Chamberlain Gate Opener shows a close input (EYE/EDGE) communication fault from another operator, check the inputs and communication method between the operators, whether it's a wired bus or radio. Ensure the operator is powered. You might need to erase the wireless communication and reprogram the two operators.
How to fix main control board failure on Chamberlain LA400DCS?
If the main control board of your Chamberlain Gate Opener has experienced an internal failure, try disconnecting all power, waiting 15 seconds, and then reconnecting the power to reboot the system. If the issue persists, the main control board may need to be replaced.
General| Type | Swing Gate Opener |
|---|---|
| Maximum Gate Weight | 850 lbs |
| Maximum Gate Length | 16 ft |
| Battery Backup | Yes |
| Safety Features | Obstruction sensing |
| Smart Phone Control | Yes |
| Control Type | Wireless Remote Control, Keypad (Optional), Smartphone App (with purchase of internet gateway) |
