15
Installation
STEP 6 Install the light bulbs
To preventpossible OVERHEATING of the end panel or light socket:
l Use ONLY A19 incandescent (100W maximum) or compactfluorescent (26W maximum) light
bulbs.
l DO NOT use incandescent bulbs larger than 100W.
l DO NOT use compactfluorescent lightbulbslarger than 26W (100W) equivalent.
l DO NOT use halogen bulbs.
l DO NOT use shortneckor specialty lightbulbs.
1. Pull on the top sides of the light lensand rotate the light lens down.
2. Insertan A19 incandescent (100W maximum) or compact fluorescent (26W,100W equivalent)
lightbulb into the light socket.
3. Rotate the lens up to close.
NOTE: Do not use halogen, short neck, or specialty light bulbs as these may overheat the end panel or
light socket. Do not use LED bulbs as they may reduce the range or performance of your remote controls.
STEP 7 Attach the emergency release rope and handle
To preventpossible SERIOUS INJURY or DEATHfrom a falling garage door:
l If possible, use emergencyrelease handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springsor unbalanced door could resultin an open door falling
rapidly and/or unexpectedly.
l NEVER use emergencyrelease handle unless garage doorway is clear of persons and
obstructions.
l NEVER use handle to pull door open or closed. Ifrope knot becomesuntied, you could fall.
1. Insertone end of the emergencyrelease rope through the handle.Make sure that “NOTICE” is
rightside up.Tie a knot at least1 inch (2.5 cm) from the end of the emergencyrelease rope.
2. Insertthe other end ofthe emergencyrelease rope through the hole in the trolley release arm.
Mount the emergency release within reach,but at least6 feet (1.83 m) above floor,avoiding
contact with vehicles to prevent accidental release and secure with a knot.
NOTE: If it is necessary to cut the emergency release rope, seal the cut end with a match or lighter to
prevent unraveling. Ensure the emergency release rope and handle are above the top of all vehicles to
avoid entanglement.
To Next Page
Loading...
Need help?
General
