33
Operation
Using your Garage Door Opener
The garage door opener can be activated through a wall-mounted door control, remote control, wireless
keyless entry or MyQ
®
accessory.
When the door is closed and the garage door opener is activated the door will open. Ifthe door senses
an obstruction or is interrupted while opening the door will stop. When the door is in any position other
than closed and the garage door opener is activated the door will close.If the garage door opener
sensesan obstruction while closing,the door will reverse.If the obstruction interruptsthe sensor beam
the garage door opener lights will blink 10 times.However, you can close the door if you hold the button
on the door control or keyless entry until the door is fully closed. The safetyreversing sensors do not
affectthe opening cycle.
The safety reversing sensor must be connected and aligned correctly before the garage door opener will
move in the down direction.
Using the Multi-Function Control Panel
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener,pressthe push bar until the garage door
opener activates (itmay take up to 3 presses).Testthe door control by pressing the push bar, each press
of the push bar will activate the garage door opener.
Push Bar
LIGHT Button
LOCK Button
Command LED
LEARN Button
MULTI-FUNCTION CONTROL PANEL FEATURES
PUSH BAR
Press the push bar to open or close the door.
LIGHTS
Light Button
Press the LIGHTbutton to turn the garage door opener lights on or off. When the lights are turned on
they will stay on until the LIGHTbutton is pressed again, or until the garage door opener is activated.
Once the garage door opener is activated the lightswill turn offafter the specified period oftime (the
factory setting is 4-1/2 minutes). The LIGHT button will notcontrol the lights when the door is in motion.
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button (approximately10 seconds) until the garage door opener lights flash.
The time interval isindicated by the number times the garage door opener flashes:
l 1 flash is 1-1/2 minutes
l 2 flashes is 2-1/2 minutes
l 3 flashes is 3-1/2 minutes
l 4 flashes is 4-1/2 minutes
To cycle through the time intervals repeat the step above.
Light Feature
The lightswill turn on when someone enters through the open garage door and the safety reversing
sensor infrared beam is broken.
l Deactivate: Press and hold the LIGHTbutton (approximately 10 seconds) until the garage door
opener lightsturn on,then offagain.
l Activate: Startwith the garage door opener lights on. Press and hold the LIGHTbutton
(approximately10 seconds) until the garage door opener lights turn off,then on again.
If the command LED is continuously blinking, the LOCK feature needs to be deactivated.
To Next Page
Loading...
Need help?
General
