203-03-9 Parking Brake 203-03-9
Disassembly and Installation
The parking brake dragline (12 675 0)
Disassembly
1. Disassemble the cover plate of the control rod of
the parking bake.
2. Put down the control rod of the parking brake.
and loosen the adjusting nut.
3. Loosen the nuts of the rear wheel tyre.
4
. Automobile hoisting.
5. Take off the left and right parking dragline
from the balancer of the front dragline of the
arking brake
p
6. Take off the rear dragline of the parking brake
from the vehicle body (both sides)
7. Disassemble the brake drum. For the relevant
information, please see section 203-02.
9. Take off the parking braking dragline.
1. Push backward the trailing shoe rod.
2. Take off the dragline from the braking trailing
shoe.
Installation
1. The installation procedures are opposite to the
disassembly sequence.
2. Adjust the parking braking. For the relevant
information, please see the section of the
parking braking dragline.
BENNI MINI
To Next Page
