203-06-9 Anti-lock Braking System 203-06-9
Disassemble and Installation
CHANA·BENNI MINI
拆卸与安装
Hydraulic Control Mechanism (HCU)
Name
Model
Brake fluid HZY4
Disassembly
Caution: If the brake fluid is inadvertently
spilled on the paint surface of the vehicle
body, rinse it immediately with clean
water.
1. Remove the negative electrode wire of the
battery. Refer to Section 407-00.
2.
Caution: the oil filler cover of the fluid
can of the braking fluid can not be
contaminated.
Take down the oil filler cover.
3. Notes: thoroughly discharging the braking fluid in
the fluid storage can is extremely necessary for the
operation at both sides.
Discharge the braking fluid in the fluid storage
can.
1. Select a proper clean plastic hose, one end is
connected with the exhaust valve and the other
end put in a suitable container.
2. Release the exhaust valve.
3. Continuously step the brake pedal until all the
braking fluid is discharged.
4. Tighten the exhaust valve.
4. Install the cover of the brake fluid storage can.
5. Remove the anti-lock (ABS) module connector
6.
Warning: cover the braking oil pipe to
prevent the braking fluid from flowing out
or the dirt from entering.
Warning: block the hydraulic control
module (HCU) to prevent the braking
fluid from flowing out or the dirt from
entering.
Notes: please mark down the position of the braking
oil pipe for installation.
Disassemble the braking oil pipe (HCU) from the
hydraulic control module.
To Next Page
