206-09-10 Anti-lock Braking System 206-09-10
Disassemble and installation (continued)
7. Warning: cover the braking oil pipe to
prevent the braking fluid from flowing out
or the dirt from entering.
Note: please mark down the position of the braking
oil pipe for installation.
Disassemble the braking oil pipe (HCU)
connected with the hydraulic control module from
the master braking pump.
8.
8. Remove the braking oil pipe.
Remove the fixing bolts at the lower part of the
hydraulic control module.
Remove the fixing bolts of the hydraulic control
module and the ABS module.
12. Remove the hydraulic control module.
Installation
1. Install in sequence adverse to the disassemble
procedure.
2. Exhaust the system. Refer to Section 203-00.
To Next Page
