203-05-5 Booster Braking System 203-05-5
Disassembly and Installation
CHANA·BENNI MINI
REMOVAL AND INSTALLATION
Brake Booster (12 451 0)
Disassembly
Warnings: If the braking fluid is splashed on
the lacquer finish of the vehicle body
carelessly, the braking fluid should be flushed
with the clean water.
1. Disassemble the master brake pump
2. Disassemble the brake booster installing bolts
3. Disassemble the brake booster.
1. Dismount the connecting pins between the brake
pushing rod and the brake pedal arm.
2.Dismount the fixing pin and the fixing clip of the
pushing rod.
Installation
1. The installation is performed according to the
procedures opposite to the disassembly.
2. For the exhausting of the braking system is
operated, refer to Section 203-00.
To Next Page
