Channel Master 4228HD - User Manual

ClJasse! Mas/er®
byPCT
Instruction Sheet
Model 4228HD
WARNING: Installation of this product near power lines is DANGEROUS!
For your safety, read the enclosed "DANGER" booklet before beginning your installation.
Front Sections
MODEL 4228HD BASIC ASSEMBLY AND MOUNTING
1. Identify the direction of the desired TV stations transmitter by using www.antennaweb.org.
2. Fold out the 2 front sections of the antenna making sure to fold out the right and left sections
simultaneously so not to put stress onto the phasing harness. Make sure that the front
sections are straight and parallel with respect to the reflector grid and securely tighten the
8 wingnuts (See Fig 1).
3. Attach the mounting hardware to the antenna as shown in Fig 2.
4. Mount antenna to mast as shown.
5. Connect coaxial cable to antenna cable connection port. Secure cable to the mast with a
cable tie to prevent strain on the cable connector.
6. Point the front of the antenna toward the TV transmitter location and adjust for best reception.
Note: The front of the antenna is the side with the X shaped elements.
7. Tighten all loose hardware.
Get the Clearest Picture and Sound
lM
",. ~ ~ RECEPTION & CONNECTIVITY
•
~ CONSUMER & PROFESSIONAL
DID PRODUCTS ._oIPCT'"",,""IlonaI . ..,
www.channelmasterintl.com
Wingnuts
Cable
Connection
Port
Wingnuts
U-bolt must be secured with bolts thru antenna.
Included Hardware
Channel Master by PCT
2151 East Broadway Road, Ste
211 ITempe, AZ 85282-19331 USA
Tel +1.480.813.0925 IFax +1.480.545.1080
© 2008 Channel Master by PCT a division of PCT International, Inc. RCCPP and Channel Master are trademarks of PCT International, Inc. Channel Master trademark is used under license. Specifications subject to change.
All rights reserved. Pub PCTCM.4228HD.INST.20080811

Summary

Channel Master 4228 HD Instruction Sheet

Basic Assembly and Mounting Guide

Step-by-step instructions for assembling the antenna and attaching mounting hardware.

Channel Master Product Warranty

Critical Safety Warnings and Procedures

Power Line Safety Guidelines

Essential safety rules to prevent electrocution when installing antennas near power lines.

Accident Response Protocol

Steps to take if an accident occurs involving power lines and the antenna system.

Antenna Site Selection and Mounting

Site Selection Criteria

Guidance on choosing a safe and optimal location for antenna installation.

Mounting Structure Types

Overview of different support structures and their height limitations for antenna mounting.

Antenna Installation and Protection

Antenna Mounting Methods

Details on various mounting techniques including roof, side, wall, and chimney installations.

Installation, Removal, and Lightning Protection

Procedures for installing, removing the antenna, and implementing lightning protection.

Mandatory Danger Label Application

Channel Master 4228HD Specifications

General

Reception Range	80 miles
Material	Aluminum
Impedance	75 Ohms
Polarization	Horizontal/Vertical
Connector Type	F-Type
Type	Outdoor Antenna
Gain	12 dB
Forward Gain	VHF 6.5 dB, UHF 12 dB
Elements	8
Mounting Type	Mast