4. If you are using a splitter, preamp, or distribution amplifier in your system, the JOINtenna should be installed
between the antennas and your splitter,
distribution amp, or preamp.
NOTE: The JOINtenna will not pass voltage through it. If your antenna requires voltage through the coaxial cable to
operate, the JOINtenna will block this voltage from getting to your antenna’s built-in preamp or rotator. It will not affect
the operation of rotators that are connected with a separate cable.
5. Turn on your television and, from the settings/set up menu, perform an auto channel scan to populate the
To Next Page
Loading...
