Note: After use, the charcoal tray may discolor.
This is normal during use.
7
Burner Flame Check
• Remove cooking grates and heat tents. Light burners,
rotate knobs from HIGH to LOW. You should see a
smaller flame in LOW position than seen on HIGH.
Perform burner flame check on side burner, also. Always
check flame prior to each use. If only low flame is seen
refer to "Sudden drop or low flame" in the
Troubleshooting Section.
HIGH
LOW
Turning Grill Off
• Turn all knobs to the OFF position. Turn LP cylinder
OFF by turning hand-wheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP cylinder. Push and slowly (2-3
seconds) turn Ignition Burner knob to . "Click"
should be heard and spark seen each time between
burner and electrode. See "Troubleshooting" if no
click or spark.
Valve Check
• Important: Make sure gas is off at LP cylinder
before checking valves. Knobs lock in OFF position.
To check valves, first push in knobs and release, knobs
should spring back. If knobs do not spring back,
replace valve assembly before using grill. Turn knobs
to LOW position then turn back to OFF position. Valves
should turn smoothly.
Hose Check
• Before each use, check to see if hoses are cut or worn
or kinked. Replace damaged hoses before using grill.
Use only valve/hose/regulator specified by
manufacturer.
Sideburner Ignitor Lighting
• Do not lean over grill while lighting.
3. Open sideburner lid.
5. If sideburner does NOT light within 5 seconds, turn
knob to OFF, wait 5 minutes, then repeat lighting
procedure.
Sideburner Match Lighting
4. Place lit match near burner.
5. Turn sideburner knob to the HIGH position. Be sure
burner lights and stays lit.
1. Turn OFF gas burner control valves.
2. Turn ON gas at LP cylinder.
3. Open sideburner lid.
1. Turn OFF gas burner control valves.
2. Turn ON gas at LP cylinder.
• Do not lean over grill while lighting.
Charcoal Lighting Instructions
1. With a cold grill, remove cooking grates and heat tents.
(Heat tents can be stored as shown.)
2. Place charcoal tray in grill.
3. Place single layer of charcoal in tray (2 lbs).
4. Replace cooking grates.
5. Ignite burners using Gas Lighting Instructions with
lid open.
6. Operate gas burners on for 15 minutes with lid
closed.
7. Turn controls knobs to .
• Do not operate gas burners for more than 15 minutes
when using charcoal
• Never use lighter fluid, kerosene, gasoline or alcohol to
light charcoal.
• Never use wood chunks, instant light or lump charcoal
in your grill.
WARNING
WARNING
CARBON MONOXIDE HAZARD
Burning charcoal inside can kill you. It gives off carbon
monoxide, which has no odor. NEVER burn charcoal
inside homes, vehicles, or tents.
After a charcoal fire appears extinguished,
unconsumed embers can retain heat for up to 24
hours, and if exposed to fresh air, can burst into
flame unexpectedly. Any such embers outside the
firebox of the grill pose a fire hazard and can ignite
combustible surfaces such as wooden decks.
WARNING
Clean up of the grill after each charcoal use is
required.
Make sure coals are completely extinguished
and the unit has adequately cooled before
cleaning.
Removed charcoal tray and clean out all ash.
Cleaning Recommendations
Proper Charcoal Tray Placement
Heat Tent Storage
Remove Cooking Grates and Heat Tents
4. To ignite, push and slowly (2-3 seconds) turn IGNITION
BURNER knob to . You should hear the ignitor click.
To Next Page
Loading...
