A
Andrew WeissOct 28, 2025
What to do if Char-Broil T-22D Grill burner won't light using ignitor?
- CChristian CoxOct 28, 2025
If the burner on your Char-Broil grill won't light with the ignitor, here are several things you can check: * Refer to the instructions on the control panel and in the Use and Care section. * Make sure the valves are correctly positioned inside the burner tubes. * Ensure the burner tubes are free from obstructions like spider webs. Check the cleaning section of the Use and Care guide. * Verify that the LP cylinder isn't empty. If it's not empty, see “Sudden drop in gas flow”. * For grills with AUTO-CLEAN™, ensure the AUTO-CLEAN™ valve is set to “Grill”. * Turn off the knobs, disconnect the coupling nut from the LP cylinder, then reconnect and try again. * Tighten the coupling nut an additional half to three-quarters of a turn until it stops, but only by hand. * Consider re...











