burner and could accidently ignite with risk of injury.
Match-Lighting
Do not lean over appliance while lighting.
1. Turn ON LP cylinder.
2. Swing match hole plate to expose match lighting hole. Place lit match into match lighting hole of
appliance as pictured below. Make sure lit match is placed inside hole and near burner.
3. Push in and turn control knob to Be sure burner lights and stays lit.
4. Once lit, swing match hole plate back to cover up match lighting hole. Caution: Plate maybe hot.
View is from side of appliance
Burner Flame Check
Light burner. Looking through viewing hole on top of appliance, you should see the flame height
as shown below. Turn control knob from to OFF. The Flame height should decrease and then go
out. Always check flame prior to each use. If only low flame is seen refer to “Sudden drop or low
flame” in the Troubleshooting Section.
Ignitor Check
• Turn gas off at LP cylinder. Turn ignitor knob. “Click” should be heard each time at electrode.
See “Troubleshooting” if no click or spark.
Valve Check
• Important: Make sure gas is off at LP cylinder before checking valve. Knob locks in OFF position. To
check valve, first push in knob and release, knob should spring back. If knob does not spring back,
replace valve assembly before using this appliance. Turn knob to position then turn back to OFF
position. Valve should turn smoothly.
Hose Check
• Before each use, check to see if hose is cut, worn or kinked. Replace damaged hose before using
appliance. Use only valve/hose/regulator specified by manufacturer.
To Next Page
Loading...
Need help?
General
