ChargePoint CP6000 Series - Page 5

ChargePoint ® CP6000 Series — Fleet
ChargePoint, Inc. | Copyright © 2022 5 of 8
General Specifications
Electrical Input
The CP6000 supports flexible wiring and power settings up to 80A. Power Select allows stations to be
installed and configured for current lower than the maximum 80A. Power Select current options include 40A,
48A, 56A, and 64A.
Power Share allows a dual-port station to share power from a single circuit across two ports, adjusting
power depending on whether one or both are charging. Standard wiring uses an independent circuit for each
port. Power Share can be used in combination with Power Select.
Electrical Input
Single Port
(AC Voltage 208 / 240V AC)
Dual Port
(AC Voltage 208 / 240V AC)
Input
Current
Input Power
Connection
Required
Service
Panel
Breaker
Input
Current
Input Power
Connection
Required
Service Panel
Breaker
Maximum 80A (Standard) 80A
One 100A
branch
circuit
100A dual
pole (non-
GFCI)
80A x 2
Two
independent
100A branch
circuits
100A dual
pole (non
GFCI) x 2
Maximum 80A (Power Share*) N/A N/A N/A 80A
One 100A
branch circuit
100A dual
pole (non
GFCI)
Power Select** 40A - 64A
(Standard)
40A -
64A
One branch
circuit rated
125% of
input
current
(50A - 80A)
Dual pole
(non-GFCI)
rated 125%
of input
current
(50A-80A)
40A -
64A x 2
Two
independent
branch
circuits rated
125% of input
current (50A -
80A)
Dual pole
(non-GFCI)
rated 125% of
input current x
2
Power Select 40A - 64A
(Power Share)
N/A N/A N/A
40A -
64A
One branch
circuit rated
125% of input
current (50A -
80A)
Dual pole
(non-GFCI)
rated 125% of
input current
(50A - 80A)
Service Panel/Breaker GFCI Do not provide external GFCI as it may conflict with internal GFCI (CCID)
Wiring – Standard
3-wire (L1, L2, Earth)
No neutral
5-wire (L1, L1, L2, L2, Earth)
Wiring – Power Share N/A 3-wire (L1, L2, Earth)
Line to Ground Voltage 120V +/- 10%