21
InstallationProduct Manual - Perma-Cyl
®
w/ FlexFill™ Piping Option
Bolting to Floor
The Perma-Cyl tank is equipped with a ange on the
bottom that has four holes for attachment. To ensure a safe
environment, the tank or pallet base should be bolted to the
oor.
1. Place tank in position with gauges facing forward.
2. Mark holes on oor, move tank.
3. Drill holes using the appropriate size masonry bit.
4. Blow out dust and insert masonry anchors.
5. Move tank back into position over holes and install lag
bolts.
6. Tighten bolts.
Figure 6 - Externally Sited/Gas Use Installation
Outdoor Installations
(Any Size)
Required:
• Open area
• Well ventilated
• At or above ground level
Photo 16 - Outdoor Installation
To Next Page
Loading...
