09
2. Operating Instruction
2.1 Getting Started
Step 1:
Open the bracket and slide down the Receiver battery cover to insert 2 AA batteries. Once batteries are inserted, the
Receiver will automatically turn on with two beeps and display a backlight, then it will enter the signal receiving state.
Step 2:
Insert the probe into the Main Unit, up to 4 can be inserted.
Step 3:
Open the back cover of the Main Unit with a screwdriver and insert 2 AA batteries (or plug in the Type-C cable). The
Main Unit will automatically turn on with two beeps and display a backlight, then display the temperature of the inserted probe
and enter the signal transmission state.
Step 4:
Once turned on the Main Unit and the Receiver will connect with each other within 30 seconds, the Receiver will display
the information of the Main Unit. If the connection is not successful, the Receiver will not display the information of the Main Unit,
or it will only display "— — —". If this happens, please repeat steps 1-3, or refer to
5. How to Sync Main Unit and Receiver
Manually
in the manual.
Note:
Wireless signals can be received within 500ft/150m between the devices in rural areas with no barriers (1m above the
ground), this will be less if transmitting between walls or barriers.
When powered by a Type-C cable, the backlight of the Main Unit will remain on all the time. When powered by batteries, the
backlight will automatically turn o after 20 seconds of no operation.
To Next Page
Loading...