ChefsTemp Quad XPro - How to Sync Main Unit and Receiver Manually; Probe Ring Installation Instruction

14
5. How to Sync Main Unit and Receiver Manually
6. Probe Ring Installation Instruction
If you need to sync the Main Unit and Receiver manually, please follow the steps below:
Step 1:
Hold on the Receiver to enter the signal receiving state. After one beep, all data of the Receiver will be reset
and the icon will begin ashing.
Step 2:
Press on the back of the Main Unit to send signals manually. The Icon will begin flashing on the Main Unit
while the Receiver will begin connecting with the Main Unit and receiving data from it.
Note:
When the Receiver loses signal for 30 seconds, the alarm will automatically ring, the backlight will be flashing and the
Receiver will be vibrating. Press any button on the Receiver to turn o󰀨 the alarm.
If the Receiver fails to receive the signal for 8 minutes, the signal receiving function will be turned o󰀨 automatically. Press
and hold the button of the Receiver for 2 seconds to restart the signal receiving function.
ChefsTemp Quad XPro has 16 probe rings (including red, yellow, green, blue, 4 rings for each color).
Always attach probe rings by sliding them over the probe tip. Attempting to attach probe rings by sliding them over the probe
jack will cause them to stretch and loosen.