ChefsTemp Quad XPro - Page 17

15
First Probe Ring:
Second Probe Ring:
Step 1:
Slide the rst of the two matching
probe rings over the probe tip.
Step 1:
Holding the second probe ring,
slide probe ring over the probe.
Step 2:
Roll the probe ring over the
metal springs of the probe.
Step 2:
Roll the probe ring over the
PEEK of the probe.
Step 3:
Slide the probe ring down the
cable until it is over the metal springs
of the probe jack. There will be a slight
groove to hold the probe ring in place.
Step 3:
Place the probe ring at the point
where the metal spring and the PEEK meet.