Chelsio Terminator Series - Uefi Fcoe Boot

Chapter I. Unified Boot Option ROM
Chelsio Unified Boot 41
6.2. uEFI FCoE Boot
6.2.1. HII
This section describes the method to configure and use Chelsio uEFI FCoE interfaces using HII.
i. Reboot the system and go into BIOS setup.
ii. Select Chelsio T5/T6 and press [Enter]
iii. Select the Chelsio adapter to be configured and press [Enter].
• Only uEFI v2.3.1, v2.4 and v2.5 supported.
• Any other uEFI version is NOT SUPPORTED and may render your
system unusable.
Important
Please ensure that Chelsio uEFI driver is loaded correctly as mentioned in
Loading uEFI driver section.
Note