Chapter I. Unified Boot Option ROM
Chelsio Unified Boot 55
xxvii. Enter BIOS setup and choose iSCSI target LUN discovered via Chelsio adapter as the
first boot device.
xxviii. Reboot and boot from the iSCSI Target LUN or install the required OS using PXE.
7.2. uEFI iSCSI Boot
7.2.1. HII
This section describes the method to configure and use Chelsio uEFI iSCSI interfaces using HII.
i. Reboot the system and go into BIOS setup.
ii. Select Chelsio T5/T6 and press [Enter]
• Only uEFI v2.3.1, v2.4 and v2.5 supported.
• Any other uEFI version is NOT SUPPORTED and may render your
system unusable.
To Next Page
Loading...