Chelsio Terminator Series User Manual

Chapter I. Unified Boot Option ROM
Chelsio Unified Boot 30
5.2. uEFI PXE Boot
5.2.1. HII
This section describes the method to configure and use Chelsio uEFI PXE interfaces using HII.
i. Reboot the system and go into the BIOS setup.
ii. Chelsio HII should be listed as Chelsio T5/T6. Highlight it and press [Enter].
iii. Select the Chelsio adapter to be configured and press [Enter].
Please ensure that Chelsio uEFI driver is loaded correctly as mentioned in
Loading uEFI driver section.
Note
• Only uEFI v2.3.1, v2.4 and v2.5 supported.
• Any other uEFI version is NOT SUPPORTED and may render your
system unusable.
Important

Chelsio Terminator Series Specifications

General

Brand	Chelsio
Model	Terminator Series
Category	Adapter
Language	English