Emergency Response
3. Pull out the head light bank carefully
and disconnect cable joints.
High beam/passing lamp bulbs
1. Push the lock catch of protective cover
to dismount the cover of passing lamp.
2. Dismount the anchor screws and pull
out the lamp holder, replace the bulb
damaged with a new bulb. Screw
down the anchor screws and well
install the protective cover of head.
3. Open the holder cover according to the
direction indicated on the cover of
high beam holder, as shown below.
4. The high beam holder can be pulled
out when the clamp spring is released,
as indicated below:
5. Pull out the plug, and take down the
bulb damaged and replace it with a
new one. Then, plug it in.
To Next Page
Loading...
