Emergency Response
6. Fix the bulb and high beam cover with
the clamp spring.
7. Calibrate lamplight of high beam with
headlight beam tester.
Notice:
Well fix the halogen bulb into the holder
necessarily.
Bulb for front turn light
1. Rotate the holder anticlockwise and
pull it out. Push the bulb with slight
pressure, and rotate the bulb
anticlockwise to take it out. Replace
the bulb.
2. Install a new bulb in a reverse order.
Bulb for parking light
The dismounting method is the same with
that of bulbs for front turn light.
Side turn light (exterior
rear-view mirror)
Turn to Chery chartered service stations
for replacement, please.
Bulb for front fog lamp
Jack the car to replace bulb for front fog
lamp from the back; or dismount the fog
lamp for replacement. Thereby, you’d
better turn to Chery chartered service
stations for replacement of bulb for fog
lamp.
Tail light bulb
1. Open the tail gate. Uncouple the
back-kick holding-down clip of tail
light bank cover inside the luggage
compartment. Pull out the light bank
slightly.
2. Screw off the holder in a direction
reverse to the locking direction
indicated on the holder to take it out.
3. Push the bulb with slight pressure and
rotate it anticlockwise to take it out.
Replace the bulb.
4. Install it in a reverse order.
5. Check if the light works regularly after
installation.
Bulb for high positioned
brake lamp
1. Open the tail gate, and dismount two
cross recessed screws to know down
the cover plate. Unshackle the
electrical joints to take the lamp bank
out, pull out the cover plate, and take
the bulb out for replacement.
2. Install the bulb in a reverse order.
Bulb for license light
Position for installation: installed under
the guard plate of license light.
To Next Page
Loading...
