Infotainment System 17
Finding a Station
Press SRCE to display the
operation screen of the current
audio source. Each operation
screen has an audio source screen
button, (AM, FM1, FM2, XM1, XM2,
if equipped, and CD). Press the
desired audio source to select it.
Preset Station Menu
Up to 30 stations, 6 AM, 6 FM1,
6 FM2, 6 XM1, and 6 XM2,
if equipped, can be programmed for
home and for away (XM does not
have the home and away feature).
To store presets:
1. Turn the audio system on.
2. Press SRCE.
3. Press AM, FM1, FM2, XM1,
or XM2, if equipped, to display
the desired source. The preset
station menu appears.
4. Tune to the desired station by
using
r O SEEK q.
5. Press SOUND to set the bass,
mid-range, treble, and Auto Tone
Control (ATC) for the preset,
if desired. See “Sound Menu”
later in this section for more
information.
6. Press and hold one of the six
numbered preset screen buttons
for more than two seconds until
a beep is heard.
7. Repeat the steps for each preset
and source.
SCAN:
.
Press to scan stations. The radio
goes to a station, plays for a few
seconds, then goes to the next
station.
.
Press SCAN again to stop
scanning.
.
Press and hold SCAN for
two seconds to scan preset
stations. It will only scan the
audio source it is in, with the
exception of FM 1 and FM 2,
which will both be scanned
if in that source.
.
Press SCAN again to stop
scanning.
To Next Page
Loading...
Need help?
General
