♦
Direct the hydraulic breaker in a position 90°
towards the object.
♦
Start near the edge and work your way in towards
the middle. Never start in the middle of large
objects.
♦
Never run the hydraulic breaker longer then 15
seconds on the same spot. Move the working tool
to a new position if the object does not break.
♦
Never bend with the working tool.
♦
Use the correct feed pressure. When the feed
pressure is correct the hydraulic breaker is working
at its best and the vibrations are at a minimum.
Also the wear on the bushing and inserted tool is
kept to a minimum.
♦
Listen to the sound from the hydraulic breaker.
The sound changes if there is any bending
between the working tool and bushing.
♦
Never run the breaker with the boom cylinders at
their end positions. It may cause damage to the
carrier.
9800 1050 01f | Original instructions18
RX 2, 3, 4, 6, 8Safety and operating instructions
To Next Page
Loading...
