Page 7SKU 66604 For technical questions, please call 1-800-444-3353.
MECHANICAL PRECAUTIONS
Prior to performing service, maintenance, or cleaning procedures, always 1.
make sure the Engine Switch is in its “OFF” position. Allow the Engine to
completely cool. Then, remove the Spark Plug Wire from the Spark Plug.
Do not alter or adjust any part of the Generator or its Engine that is 2.
assembled and supplied by the manufacturer or distributor.
Always follow and complete scheduled Engine maintenance.3.
CHEMICAL PRECAUTIONS
Avoid contact with hot fuel, oil, exhaust fumes, and solid surfaces.1.
Avoid body contact with fuels, oils, and lubricants used in the Engine. 2. If
swallowed, seek immediate medical treatment. Do not induce vomiting if fuel is
swallowed. For skin contact, immediately wash with soap and water. For eye
contact, immediately ush eyes with clean water.
NOISE PRECAUTION
Prolonged exposure to high noise levels is hazardous to hearing. Always
wear ANSI-approved hearing protection when operating or working around the
Generator when it is running.
ELECTRICAL PRECAUTIONS
All connections and conduits from the Generator to the load must only be installed 1.
by trained and licensed electricians, and in compliance with all relevant local,
state, and federal electrical codes and standards, and other regulations where
applicable.
The Generator must be earth-grounded in accordance with all relevant electrical 2.
codes and standards before operation.
To Next Page
Loading...