nd
PULL
Locate the LATCH anchor bars in your vehicle. Attach both LATCH
Connectors to the vehicle LATCH anchor bars.
Pull up on the end of the LATCH Adjuster strap (Pull 1
st
) until
strap is tight.
Pull on the SuperCinch
™
LATCH Tightener strap (Pull 2
nd
) to secure the
Child Restraint.
INSTALL USING LATCH INSTALL USING LATCH
5
4
6
4
CHECK YOUR WORK
Hold Child Restraint at each side near REAR-FACING vehicle belt paths. Pull side
to side and forward. Child Restraint should not move more than 1” (25 mm) from
vehicle seat back or side-to-side.
Make sure Child Restraint is level for REAR-FACING use. Make sure infant’s head
does not fall forward. If necessary, loosen the Latch Strap, re-adjust recline and
repeat installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
PULL
1
5
To Next Page
Loading...
