42
43
REAR-FACING INSTALLATION
REAR-FACING INSTALLATION
INSTALL USING LATCH
2
PULL
1
PULL
2
1
3
Make sure SuperCinch
™
LATCH Tightener strap
(Pull 2
nd
) is loosened to
the full length.
Make sure LATCH
Adjuster strap (Pull 1
st
)
is loosened to the full
length.
INSTALL USING LATCH
Locate the LATCH Connector Storage compartments. Remove LATCH
straps. Make sure SuperCinch
™
LATCH Tightener strap (Pull 2
nd
)
and LATCH Adjuster strap (Pull 1
st
) are loosened to their full length.
Grab both ends of LATCH straps. Slide LATCH strap to blue
REAR-FACING opening on both sides. Note: Both LATCH Connector
Storage compartments must be open and both LATCH straps must be
loosened to their full length in order to slide LATCH straps into
position.
Close both LATCH Connector Storage compartments.
1
2
When not accessing the LATCH or changing the belt path
ALWAYS keep LATCH Connector Storage compartments closed.
3
Do not use the lower anchors of the child restraint anchorage system
(LATCH system) to attach this Child Restraint when restraining a child weighing
more than 35lbs (16 kg) with the internal harness of the child restraint.
To Next Page
Loading...
