Chikusui Canycom CM 221 - Page 3

7. Maintenance 25
7.1 Periodic Inspection Table ....... ............ ............ ............. 25
7.2 Fuel / Grease / Lubricant / Fluid Chart .. ............ ............ ... 28
7.3 Consumable (Replacement Parts) Chart ......................... 29
7.4 Adding Oil .......... ............ ............ ............ ............... 30
7.4.1 Engine Oil ............ ............ ............ ............ ............ 30
7.4.2 Transmission Oil .... ............ ............ ............ ............ ... 31
7.4.3 HST Oil ........... ............ ................... ............ ......... 32
7.4.4 Cutter Blade Case . ............ ............ ............ ............ .... 33
7.5 Lubrication and Greasing ......... ............ ............ ........... 34
7.6 Adding Water (Battery Fluid) .. ............ ............ .............. 35
7.7 Cleaning ......... ............ ............ ................... ........... 36
7.7.1 Air Cleaner Element .......... ............ ................... .......... 36
7.7.2 Ignition Plug ........ ............ ............ ............ ............ ... 36
7.7.3 Rotating Screen ......... ............ ............ ................... ... 37
7.8 Adjustments ....... ............ ................... ............ ......... 37
7.8.1 Running V-belt ........ ............ ............ ............ ............ 37
7.8.2 Blade Rotary V-belt ..... ............ ............ ............ .......... 38
7.8.3 Rotary Stopper .... ............ ............ ............ ............ .... 39
7.8.4 Brake Pedal ... ............ ............ ............................... . 39
7.8.5 HST Pedal ...... ............ ............ ............ ............ ...... 39
7.8.6 Tire Pressure ............................ ............ ............ ...... 40
7.9 Replacement ............. ............ ............ ............ ......... 40
7.9.1 Oil Filter ......... ............ ............ ................... .......... 40
7.9.2 Fuel Pipe, HST Oil Tank Connection Hose ........................... .... 40
7.9.3 Cutter Blade ......... ............ ............ ................... ...... 40
7.10 Maintenance After Use ......... ............ ............ ............ 41
6.4 Stopping Procedure ....... ............ ............ ............ .......... 20
6.5 How to Avoid Slippage of Rear Wheels................. ............ ... 21
6.6 How to Operate Blade ......... ............ ............ ............ ...... 22
6.7 How to Transport the Machine in Case of Emergency ......... ...... 24