Chino AH3000 Series - User Manual

Questions and Answers

S
Sarah GoodmanAug 8, 2025
How to troubleshoot Chino AH3000 Measuring Instruments when it is not working?
- T
  Timothy AveryAug 8, 2025
  First, ensure the external power source is on. Then, verify that the power supply meets the specified requirements (100 to 240 VAC 50/60Hz). Check the power cable connection to the terminals (L, N) to ensure it is correct. Try turning the external power supply off and on again. As a last resort, initialize the programmed values to see if the instrument returns to normal. Note that this will reset all programmed values to default, requiring you to program them again.
K
Katherine HudsonAug 12, 2025
What to do if measured values are unstable on Chino Measuring Instruments?
- C
  Cameron MunozAug 12, 2025
  Check the measuring terminals for any looseness. Also, verify if the input signal itself is unstable. Finally, make sure the thermocouple is not connected in parallel with another instrument and that the burnout function is not enabled.
A
Ashley BriggsAug 16, 2025
Why does an error occur on Chino AH3000 Measuring Instruments?
- M
  Melissa StantonAug 17, 2025
  First, check that the °C/°F operation selection is correct. Next, verify that the input signal is correct. If using a thermocouple input, ensure the extension wire is properly connected to the input terminals. If an error is detected, check the scale and adjust measured values.
R
Rachel AliAug 20, 2025
How to fix no printing on Chino AH3000?
- S
  Seth PerkinsAug 21, 2025
  Verify that printing is turned on. Also, check if the cassette ribbon is mounted correctly.
K
Katie GreeneAug 26, 2025
What to do if the chart feed is abnormal in Chino Measuring Instruments?
- K
  Kevin PhillipsAug 26, 2025
  Check if the chart is unlatched from the sprocket. Ensure the chart cassette is securely inserted into the internal unit. Also, verify that the chart has not been shuffled before loading.
M
Mary ShermanAug 29, 2025
Why is the printing color thin on my Chino AH3000?
- M
  Mr. Shawn GarciaAug 29, 2025
  The most likely cause is that the cassette ribbon needs to be replaced.
C
clarkemilySep 2, 2025
Why programmed values remain unchanged after I change them on Chino AH3000 Measuring Instruments?
- M
  Michael GibsonSep 2, 2025
  Programmed values are not stored into memory without pressing + keys when the values are programmed every channel.

Chino AH3000 Series Specifications

General

Input Type	DC Voltage, Thermocouple, RTD, DC Current
Chart Width	100 mm
Power Supply	100 to 240 VAC ±10%, 50/60 Hz
Measurement Range	Depends on input type
Response Time	1 second or less
Operating Temperature	0 to 50°C

Related product manuals

Chino AH4000

131 pages

Chino AH3000 Series - User Manual

Table of Contents

Questions and Answers

Chino AH3000 Series Specifications

Related product manuals