Chord 2go - Manual Wi-Fi Network Setup; Manual Wi-Fi Hotspot Setup; Factory Reset Procedure

Chord Electronics
2go | User manual
22
Wi-Fi network mode
Network mode allows 2go to connect to an available Wi-Fi network.
1. Select “mode: enter Network mode” by using the Configuration button
B
.
TIP
2go is available for Wi-Fi connection when the 2go status LED
E
starts to flash blue.
TIP
2go will automatically look for or connect to a known Wi-Fi network. A new Wi-Fi network must first
be added in the browser configuration menu. See chapter 7 on how to connect to a Wi-Fi network.
13.4 Wi-Fi hotspot mode
W-Fi Hotspot mode allows you to connect to a Wi-Fi network created by your 2go. It acts as a
replacement for Wi-Fi when no external network is available.
1. Select “mode: enter Hotspot mode” by using the Configuration button
B
. The 2go status LED
E
will flash blue and green when 2go is in Hotspot mode.
2. Enable Wi-Fi on your control device.
3. Select 2go-XXXXX to connect to the hotspot, where XXXXX is a number unique to your 2go.
13.5 Factory reset
The factory reset option allows you to erase all user adjustable information from 2go’s memory (e.g.
Wi-Fi networks, passwords and playlists).
1. Select “factory reset” by using the Configuration button
B
.
NOTICE
Remove your MicroSD card from 2go before running a factory reset. 2go will otherwise
re-index the card as soon as the reset is complete.
NOTICE
The name of your 2go may not reset when re-connecting 2go to a previously connected
control device. The name will reset once the Bluetooth cache is updated.
TIP
The factory reset option is also available in the GoFigure app (see chapter 11).