Chord Electronics
2go | User manual
9
7 Connecting 2go to Hugo 2
To connect 2go to Hugo 2:
1. Screw the connector pins
M
into
the front of Hugo 2 until finger tight.
NOTE: please do not over-tighten as this
will damage your Hugo 2
2. Gently attach 2go to Hugo 2.
3. Tighten 2go’s locking hex screws
A
with the provided Allen wrench
N
.
4. If your two devices are not
connecting with ease, please slightly
loosen the connector pins half a turn
and re-join the two devices
NOTICE
To Next Page
Loading...
