Powering On and Playback
– Press and hold the power button to turn the Mojo 2 on.
– Once connected to a music source via the digital inputs, press and hold the ‘-’ volume button until both the ‘+’ and ‘-’ are unlit.
– Attach your headphones or IEMs and slowly keep pressing the ‘+’ until it reaches an ideal volume for you.
– Pressing the ‘-’ again once at no volume will toggle the device to Low Gain mode. We recommend using Low Gain
mode for most IEMs and sensitive headphones.
– Similarly, pressing ‘+’ up to the maximum volume and then pressing “+” will enable High Gain Mode. Use High
Gain mode for headphones that need the extra power.
– After making your adjustments, make sure your volume is set to zero before plugging in your headphones.
– Plug in your headphones or IEMs and press ‘+’ until you have reached your desired listening volume.
It is best practice to set the volume down to zero when switching between headphones, as they can have very dierent
impedances and sensitivities. This means that a volume setting that matches one headphone might be dangerously loud
for a dierent headphone.
Safety and Maintenance
– Keep the Mojo 2 from direct contact with water or other liquids.
– Only clean the Mojo 2 with a microber cloth.
– Attempting to open, dismantle, or internally apply third-party devices to the Mojo 2 will invalidate your warranty.
Register your Mojo 2 via the Chord Electronics website.
To Next Page
Loading...
Need help?
General
