16
everyday use of the SPM 600
SPM 1200C
SPM 1200E
SPM 1400E
SPM 6000
turning on your amplifier
1. When you plug your amplifier into the mains the power indicator on the front
panel will glow red which means that the amplifier is in standby mode.
2. Press the power button beneath the power indicator and it will then glow green
indicating that the amplifier is ready for use.
3. If you then press speaker button A or B there will be a delay of about 12 seconds
before you hear the signal. This is to allow the amplifier to stabilise. The
loudspeaker indicators (A or B) on the front panel will then illuminate blue.
automatic shutdown
1. If there is a major overload or short circuit the amplifier will shut down
automatically and the power indicator will fade and switch to red. The amplifier
should be immediately switched off at the mains.
2. When the fault has been rectified the amplifier can be switched on and will power
up as usual. You should wait at least two minutes before turning the amplifier on
again at the mains to allow the power supply protection circuitry to reset itself.
To Next Page
Loading...
