Need help?Do you have a question about the Chore-Time Chore-Tronics Model 16 and is the answer not in the manual?
General| Category | Control Unit |
|---|---|
| Manufacturer | Chore-Time |
| Model | Chore-Tronics Model 16 |
| Frequency | 50/60 Hz |
| Number of Feed Cycles | Up to 16 |
Outlines essential safety practices for operating and installing the control system.
Details critical warnings regarding backup systems, access codes, and avoiding water damage.
Attaching decals to switches to associate device names with relay numbers for control configuration.
Details answering questions and adjusting settings in specific screens for initial setup.
Lists equipment and assigned ON/OFF temperatures for control operation.
Describes how to enable, disable, or test the alarm system.
Lists possible alarm conditions detected by the control system.
Explains how high temperature difference relative to set temperature is configured.
Explains how maximum/minimum temperature limits function as backup and relative limits.
Details the logic for high and low static pressure alarms, including delays.
Explains 'Today's Day' and 'Curve Value' for setting temperature based on age.
Describes curve bend points, assigned days, and set temperatures.
Details setting up the control for specific house management needs, including house equipment.
Explains setting curtain speeds and initial/full movement inches.
Setting house identification, temperature, and measurement units.
Answering questions to configure the house and control for specific ventilation modes.
Setting curtain speeds and initial/full curtain opening movement in inches.
Assigning sensors to control outputs and designating backup sensors for failure events.
Explains assigning sensors to modes and outputs to relays with mode specifics.
Assigning sensors to outputs and designating backup sensors for failure events.
Details calibration for the optional humidity indicator.
Explains setting and using a four-digit access code for security.
Lists causes and solutions for screen blankness or unresponsiveness.
Addresses issues with outputs not responding or relays being non-functional.
Covers troubleshooting dead controls, sensor failures, and static pressure alarms.
To Next Page
