Introduction to Control Chore-Tronics Model 16 & 8 Control
16
MT1554A 1/6/99
How to Maneuver in the Viewing Screen
• The procedures below give a brief overview on the use of the Navigation Buttons
and the Edit Buttons.
• For this example we will be looking at the Setup and Calibration Screen. (Button
12 on the Control front panel).
Usin
the Navi
ation Buttons
1. Press BUTTON 12.
Setup and Calibration screen for viewing appears (Figure 1).
At this point you can move from line to line by pushing the DOWN ARROW or
the UP ARROW. This will cause the text to either scroll up or down one line at
a time.
2. Press the DOWN ARROW once.
The text will scroll one line (Figure 2). If you push the UP ARROW once the
text will scroll back to the previous line.
The LEFT and RIGHT arrow ke
s are onl
functional in the
Edit Mode.
See followin
pa
e on the use of the
Edit Buttons.
Figure 1. Setup and Calibration Screen.
"/
( 0*"1"'(
2 3 114,('%
%5!6# "
( 3# .
- ,#
Figure 2. Setup and Calibration Screen.
( 0*"1"'(
2 3 114,('%
%5!6# "
( 3# .
- ,#
{Note}
*
9/9/98
To Next Page
Loading...
