Safety Summary
The following general safety precautions must be observed during all phases of
operation, service, and repair of this instrument. Failure to comply with these
precautions or specific WARNINGS given elsewhere in this manual will violate
safety standards of design, manufacture, and intended use of the instrument.
Chroma assumes no liability for the customer’s failure to comply with these
requirements.
BEFORE APPLYING POWER
Verify that the power is set to match the rated input of this
power supply.
PROTECTIVE GROUNDING
Make sure to connect the protective grounding to prevent an
electric shock before turning on the power.
NECESSITY OF PROTECTIVE GROUNDING
Never cut off the internal or external protective grounding
wire, or disconnect the wiring of protective grounding
terminal. Doing so will cause a potential shock hazard that
may bring injury to a person.
FUSES
Only fuses with the required rated current, voltage, and
specified type (normal blow, time delay, etc.) should be
used. Do not use repaired fuses or short-circuited fuse
holders. To do so could cause a shock or fire hazard.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of flammable
gases or fumes.
DO NOT REMOVE THE COVER OF THE INSTRUMENT
Operating personnel must not remove the cover of the
instrument. Component replacement and internal
adjustment can be done only by qualified service personnel.
viii
To Next Page
Loading...
Need help?
General
