Need help?Do you have a question about the Chroma 63206 and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 63206 |
| Category | Test Equipment |
| Language | English |
Technical specifications of the electronic load, including AC input, fuse, frequency, and maximum VA.
Explanation of the four operational modes: Constant Current (CC), Constant Resistance (CR), Constant Voltage (CV), and Constant Power (CP).
Details on the load's protection features: Over voltage, Over current, Over power, Over temperature, Reverse Voltage, and Fan Fail.
Guide on selecting and setting operational modes (CC, CR, CV, CP) and their parameters like current, resistance, voltage, power, and slew rate.
Instructions on selecting and setting up programs and sequences for automatic test execution.
Procedure for running a programmed sequence, including interpreting results and status.
How to enable/disable specification checking and set HIGH/LOW boundaries for measurements.
Steps to configure the electronic load's features like Von point, current limit, and auto load settings.
Lists generic commands and queries defined by IEEE488.2 standard, starting with a '*'.
Detailed explanations for common commands like *CLS, *ESE, *ESR?, *IDN?, *OPC, *RCL, *RST, *SAV, *SRE, *STB?.
Commands for configuring various aspects of the electronic load, including auto load, display, keys, and remote settings.
Commands for configuring communication interfaces like GPIB, RS485, and serial parameters (baud rate, bits, parity).
Commands for setting static and dynamic load currents, including levels, slew rates, and timings.
Commands to fetch measured data such as current, power, resistance, voltage, and status.
Commands related to load state, short-circuit simulation, key modes, protection, and saving.
To Next Page
