Need help?Do you have a question about the Chroma 63202 and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 63202 |
| Category | Test Equipment |
| Language | English |
Details AC input, fuse, frequency, and various performance ratings of the load.
How to connect the load for remote operation via GPIB, RS-232C, or remote controller.
Details the four primary operating modes: Constant Current, Resistance, Voltage, and Power.
Describes the load's ability to handle short-term power overdriving for simulation.
Details protection features like Over voltage, Over current, Over power, Over temperature, and Fan fail.
Step-by-step guide to select and set parameters for CC, CR, CV, and CP modes.
How to select, chain, and configure programs for automatic testing sequences.
Instructions on how to execute a programmed test sequence and interpret results.
How to enable and set specification checking (GO/NG) with HIGH, LOW, and CENTER levels.
Setting up configuration parameters like Von point, current limit, and display options.
Details commands for configuring system settings, including Auto Load On, display, and remote control.
Commands for setting communication parameters like GPIB address, RS485 address, and serial port settings.
Commands for setting static and dynamic load current levels and slew rates.
Commands for controlling load state, short circuit simulation, and protection features.
Command to set the operational mode of the electronic load.
Commands for setting static and dynamic power levels and slew rates.
Commands for managing program sequences, files, and execution modes.
Commands for setting static resistance levels and slew rates.
Commands for setting specification limits (C, L, H) and enabling/disabling tests.
Commands for querying and managing status registers and conditions.
Commands for setting current limits, voltage levels, and response speeds in CV mode.
To Next Page
