Need help?Do you have a question about the Chroma 63203 and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 63203 |
| Category | Test Equipment |
| Language | English |
Details the electrical and operational specifications for the 63200 series electronic loads.
Details how to connect the electronic load for various application scenarios.
Explains how to switch between and manage local (front panel) and remote control modes.
Covers the different operational modes: CC, CR, CV, and CP.
Explains how to control the load using the front panel keypad and display.
Guides on setting the operation modes (CC, CR, CV, CP) and their parameters locally.
Details how to set up and manage test programs for automatic execution.
Describes how to configure GO/NG (Pass/Fail) specification checking.
Covers setting up various operational parameters and features via the configuration menu.
Details commands for configuring various settings like AUTO LOAD ON, MODE, DISPLAY, etc.
Covers commands for setting communication parameters like GPIB address, RS485 address, and serial settings.
Details commands for setting static and dynamic current levels, slew rates, and timings.
Covers commands for controlling the load state, short circuit simulation, and protection features.
Details commands for managing and executing test programs, sequences, and timing.
Explains commands for setting GO-NG specifications, test parameters, and units.
Details commands for querying and managing the status registers and conditions.
Details commands for system-level configurations like parallel operation and data transfer.
To Next Page
