Need help?Do you have a question about the Chroma 63630-80-60 and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 63630-80-60 |
| Category | Power Supply |
| Language | English |
Details the front panel keys and indicators of the mainframe and load modules for operation.
Guides on setting the operational modes (CC, CR, CV, CP, CZ) for static load operations.
Details how to set up and operate the electronic load in dynamic load modes.
Explains the initial setup and configuration parameters for the electronic load system.
Lists detailed technical specifications for the 63600-5 and 63601-5 mainframes.
Guides on the procedure for installing load modules into the mainframe, emphasizing anti-static practices.
Covers the process of installing the mainframe, including environmental and ventilation requirements.
Explains how to connect the electronic load for various application scenarios, including load and remote sensing.
Describes the front panel layout, including displays, keys, and indicators of the mainframes.
Details the rear panel connectors and features of the mainframes for connectivity and cooling.
Explains the difference between local and remote control modes and how to switch between them.
Details the Constant Current (CC) mode, including current ranges, static, and dynamic load operations.
Explains the operation of the dynamic load mode, including parameter setup for levels, slew rates, and timing.
Describes the Constant Resistance (CR) mode, covering resistance programming and voltage/current ranges.
Details the Constant Voltage (CV) mode, including voltage programming and current limit settings.
Explains the Constant Power (CP) mode, covering power programming and slew rate levels.
Describes the Constant Impedance (CZ) mode, including parameter settings for R, L, and C.
Lists the built-in protection features, including over-current, over-power, and over-temperature protection.
Introduces basic concepts of programming the electronic load using SCPI commands.
Provides a comprehensive dictionary of commands and subsystems for remote programming.
Verifies if current programming and readings in CC mode are within specifications.
Verifies if resistance programming in CR mode is within specifications.
To Next Page