Need help?Do you have a question about the Chroma 63600-2 and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 63600-2 |
| Category | Power Supply |
| Language | English |
Verify power is set to match the rated input before applying power.
Ensure protective grounding is connected to prevent electric shock before turning on power.
Never cut off or disconnect the protective grounding wire; it poses a shock hazard.
Highlights product capabilities.
Essential technical details for the instrument.
Explains the procedure for installing load modules into the mainframe.
Details the process of installing the mainframe unit and its line voltage considerations.
Covers connecting the load to the UUT, including load, remote sensing, parallel, and multi-mainframe connections.
Describes the front panels of the 63600-5, 63601-5, 63600-2, and 63600-1 mainframes, including displays and keypads.
Details the rear panel connectors and features of the 63600-5, 63601-5, 63600-2, and 63600-1 mainframes.
Explains local front panel control and remote control via interfaces, and how to switch between them.
Describes the five operation modes: CC, CR, CV, CP, and CZ, including their characteristics and parameter settings.
Details the current and voltage measurement capabilities, sampling rate, and resolution.
Explains slew rate definition and its impact on transition time and minimum transient time.
Explains how to set conducting voltage (Von) to control start/stop sinking current.
Details how to simulate a short circuit at input by setting the load on with full-scale current.
Describes the digitizing function for recording transient waveforms, including sampling time and points.
Explains the timing measurement function for precise time measurements in battery discharge tests.
Describes the sine wave loading current function, allowing setting of current bias, AC current, and frequency.
Lists protection features: Over Current, Over Power, Over Temperature, and Reverse Voltage Warnings.
Guides on setting static load modes (CC, CR, CV, CP, CZ) and their parameters.
Details setting dynamic load modes (CC, frequency sweep) and their parameters.
Provides a comprehensive list of common and specific GPIB commands organized by subsystem.
Details performance tests for CC, CR, CV, CP, and Dynamic/Slew Rate modes.
To Next Page