Chroma 63600 Series - User Manual

Chroma 63600 Series Specifications

General

Series	63600
Operating Temperature	0°C to 40°C
Modes	CC, CV
Interface	GPIB, USB
Protection	OCP, OTP, OVP
Voltage Resolution	1mV
Cooling	Forced Air

Summary

Specifications

Installation

Installing the Modules

Turn-On Self-Test

Application Connection

2.6.1 Load Connections

Guidelines for safe and correct connection of the UUT to the load module, including wire size.

Remote Control Connection

Front Panel Description

Front Panel Keys & Indicators of the Mainframe

Identifies and explains mainframe front panel controls and indicators for local operation.

Rear Panel Description

Rear Panel Connectors on the Mainframe

Details the purpose and location of all connectors on the mainframe rear panel.

Local;Remote Control

Modes of Operation

3.5.1 Constant Current Mode

Describes the Constant Current (CC) mode, its settings, and operational characteristics.

Dynamic Load Mode

Dynamic Load Frequency Sweep Mode

Constant Resistance Mode

Constant Voltage Mode

Constant Power Mode

Constant Impedance Mode

Program Sequences Function

Protection Features

Save;Recall Setting

Local Operation

Front Panel Keys & Indicators

4.2.1 Front Panel Keys & Indicators of the Mainframe

Identifies and explains mainframe front panel controls and indicators for local operation.

Front Panel Keys and Indicators of the Load Module

Front Panel Keys (Load module)

Setting Operation Mode of Static Load

4.4.1 Setting the Operation Mode

Details how to select the desired operation mode (CC, CR, CV, CP, CZ).

4.4.2 Setting CC Values

Explains how to set current levels and slew rates in CC mode.

Setting CR Values

Setting CV Values

Setting CP Values

Setting CZ Values

Setting Operation Mode of Dynamic Load

4.5.1 Setting the Operation Mode to CC Mode

Explains how to select CC mode for dynamic load operation.

Select the Operation Mode of Dynamic Load

Setting Dynamic Load Values

Setting Dynamic Load Frequency Sweep Values

Setup of Program Sequences Function

Running the Program Sequences Function

Setting the Configuration

4.7.1 Setup of System Configuration

Explains initial system configuration settings like voltage range and Von point.

Setup of Specification

Setup of REMOTE

Recalling Files

Saving File;Default

Going To Local

4.10.1 Lock Operation

Remote Operation

Setting Network Parameter (IP, Subnet Mask, Gateway)

Confirming Network Connection is Successful

Introduction to Programming

5.2.1 Basic Definition

Explains programming concepts: simple, compound, and query commands.

Language Dictionary

5.3.1 Common Commands

Specific Commands

ADVANCE Subsystem

CHANNEL Subsystem

CONFIGURE Subsystem

CURRENT Subsystem

DIGITIZING Subsystem

FETCH Subsystem

IMPEDANCE Subsystem

LOAD Subsystem

MEASURE Subsystem

MODE Subsystem

POWER Subsystem

PROGRAM Subsystem

RESISTANCE Subsystem

SPECIFICATION Subsystem

STATUS Subsystem

VOLTAGE Subsystem

SYSTEM Subsystem

Status Reporting

Register Information in Common

Channel Status

Status Byte Register

Verification

7.2 Equipment Required

Performance Tests

7.3.1 CC Mode Verification

Checking High Current Range

Checking Medium Current Range

Checking Low Current Range

CR Mode Verification

7.3.2.1 Checking High ohm Range

Checking Medium ohm Range

Checking Low ohm Range

CV Mode Verification

7.3.3.1 Checking High Voltage Range

Checking Medium Voltage Range

Checking Low Voltage Range

CP Mode Verification

Checking High Power Range

Checking Medium Power Range

Checking Low Power Range

Dynamic & Slew Rate Circuit Test

Checking Dynamic Constant Current High Range

Checking Dynamic Constant Current Medium Range

Checking Dynamic Constant Current Low Range

Precautions for Loading Battery

Precautions for Loading Battery

Measures for Improvement

Additional Protection Switch

Operation