Chroma 63600 Series - PROGRAM Subsystem

Programmable DC Electronic Load 63600 Series Operation & Programming Manual
5-72
5.3.2.13 PROGRAM Subsystem
:NSELect
SP
<NR1>
?
SP
<arg1>,<arg2>,<arg3>,<arg4>,<arg5>
?
MAX
MIN
<NR1>
:PROGram
:SAVe
:SEQuence
:CLEar
:REMain
SP
<NR1>
?
<NR1>
:DATA
SP
:STATe
:FAIL
?
:LIST
:STEP
SP
<arg1>,<arg2>,……,<arg16>
?
MAX
MIN
SP
SP
<arg1>,<arg2>,……,<arg16>
?
MAX
MIN
SP
?
<arg1>,<arg2>
<arg1>
<AARD>
<AARD>
<AARD>
<AARD>
<AARD>
<AARD>
<AARD>
<AARD>
<AARD>
<AARD>
<arg1>
SP
SP
SP
:SPECification
?
<DLABRD>
SP
<arg1>,<arg2>
PROGram:DATA
Type: Channel-Specific
Description: Set the program parameters. (Note: All setting parameters in this
command can’t use suffix.)
Setting Syntax: PROGram:DATA<space><Arg1>,<Arg2>,<Arg3>,<Arg4>,<Arg5>
Setting Parameters:
Selects a program to be set:
Arg1: <NR1>, 1 ~ 10, Resolution = 1, Unit = None.
Set the type of program:
Arg2: <NRf>, LIST(0), STEP(1), Unit = None.
Set the chain parameter in program:
Arg3: <NR1>, 0 ~ 10, Resolution = 1, Unit = None.
Set the repeat count of program:
Arg4: <NR1>, 0 ~ 9,999, Resolution = 1, Unit = None.
Set number of sequence in program: