Programmable DC Electronic Load 63600 Series Operation & Programming Manual
5.3.2.21 SYSTEM Subsystem
SYSTem:ERRor?
Type: All Channels
Description: This command queries the error string of the command parser.
Setting Syntax: None
Setting Parameters: None
Query Syntax: SYSTem:ERRor?.
Return Parameters: <ACCRD>, 0,"No Error",
1,Data Format Error",
2,Data Range Error",
3,Command Error",
4,Execution Error",
5,Too Many Errors"
Query Example: SYST:ERR?
SYSTem:REMote
Type: All Channels
Description: This command can only be used under control of USB and Ethernet.
If SYST:REM is programmed, the 63600 will be set in the REMOTE
state, and the front panel of frame will be disabled except the
<LOCAL>key pressed.
Setting Syntax: SYSTem:REMote
Setting Parameters: None
Setting Example: SYST:REM
SYSTem:LOCal
Type: All Channels
Description: This command can only be used under control of USB and Ethernet.
If SYST:LOC is programmed, the 63600 will be set in the LOCAL
state, and the front panel will work.
Setting Syntax: SYSTem:LOCal
Setting Parameters: None
Setting Example: SYST:LOC
M
Type: All Channels
Description: Set the load mode to the ten channels in one frame. The frame will
ignore the setting if the channel does not exist.
Setting Syntax: M<space>“n,n,n,n,n,n,n,n,n,n”
Setting Parameters: <NR1>, 0: do not change, 1: CCL, 2: CCM, 3: CCH, 4: CRL, 5:
CRM, 6: CRH, 7: CVL, 8: CVM, 9: CVH, 10: CPL, 11: CPM, 12:
CPH, 13: CZL, 14: CZM, 15: CZH, 16: CCDL, 17: CCDM, 18: CCDH,
19: CCFSL, 20: CCFSM, 21: CCFSH, 22: TIML, 23: TIMM, 24:
TIMH, 25: SWDL, 26: SWDM, 27: SWDH, 28: OCPL, 29: OCPM, 30:
OCPH, 31: PROG, 34: MPPTL, 35: MPPTM, 36: MPPTH, 37:
UDWL, 38: UDWM, 39: UDWH
Example: M “1,1,2,2,2,2,5,5,0,0”
M ”2,2,2,2,2,2”
AC
Type: All Channels
Description: Set the current level 1(L1) of CC mode to the ten channels in one
frame. The frame will ignore the setting if the channel does not exist.
To Next Page
Loading...
Need help?
General
