EasyManua.ls Logo

Chroma 63600 Series - Page 225

Default Icon
258 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote Operation
5-93
Setting Syntax: AC<space>“n,n,n,n,n,n,n,n,n,n
Setting Parameters: <NR2>, [Unit=Ampere]
Example: AC “1.0,1,2.5,5.0,10.5,4.5,2.0,2.0,0,0”
AR
Type: All Channels
Description: Set the resistance level 1(L1) of CR mode to the ten channels in one
frame. The frame will ignore the setting if the channel does not exist.
Setting Syntax: AR<space>“n,n,n,n,n,n,n,n,n,n
Setting Parameters: <NR2>, [Unit=OHM]
Example: AR “1.0,0.1,0.2,0.5,0.15,0.4,0.2,0.2,0,0”
AV
Type: All Channels
Description: Set the voltage level 1(L1) of CV mode to the ten channels in one
frame. The frame will ignore the setting if the channel does not exist.
Setting Syntax: AV<space>“n,n,n,n,n,n,n,n,n,n
Setting Parameters: <NR2>, [Unit=Volt]
Example: AV “5.0,5.5,3.3,5.1,12.0,5.5,5.0,5.2,0,0”
AP
Type: All Channels
Description: Set the power level 1(L1) of CP mode to the ten channels in one
frame. The frame will ignore the setting if the channel does not exist.
Setting Syntax: AP<space>“n,n,n,n,n,n,n,n,n,n
Setting Parameters: <NR2>, [Unit=Watt]
Example: AP “50.0,100.0,30,5.1,12.0,5.5,5.0,5.2,0,0”
CCR
Type: All Channels
Description: Set the rising slew rate of CC mode to the ten channels in one frame.
The frame will ignore the setting if the channel does not exist.
Setting Syntax: CCR<space>“n,n,n,n,n,n,n,n,n,n
Setting Parameters: <NR2>, [Unit=A/μs]
Example: CCR “1.0,2.5,2.5,10,2.0,5.0,5.0,5.0,0,0”
CCF
Type: All Channels
Description: Set the falling slew rate of CC mode to the ten channels in one
frame. The frame will ignore the setting if the channel does not exist.
Setting Syntax: CCF<space>“n,n,n,n,n,n,n,n,n,n”
Setting Parameters: <NR2>, [Unit=A/μs]
Example: CCF “1.0,2.5,2.5,10,2.0,5.0,5.0,5.0,0,0”
CPR
Type: All Channels
Description: Set the rising slew rate of CP mode to the ten channels in one frame.
The frame will ignore the setting if the channel does not exist.
Setting Syntax: CPR<space>“n,n,n,n,n,n,n,n,n,n”
Setting Parameters: <NR2>, [Unit=A/μs]
Example: CPR “1.0,2.5,2.5,10,2.0,5.0,5.0,5.0,0,0”
CPF
Type: All Channels

Table of Contents

Related product manuals