Need help?Do you have a question about the Chroma 63640-80-80 and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 63640-80-80 |
| Category | Power Supply |
| Language | English |
Lists detailed specifications for the mainframe and load modules.
Provides procedures for installing load modules into the mainframe, warning about static electricity.
Details mainframe installation, ventilation, voltage input, and remote control connections.
Details pre-test checks and the self-test procedure upon powering on the load.
Covers load connections, remote sensing, parallel, multi-mainframe, and remote control connections.
Describes the front panel components of mainframes 63600-5, 63601-5, 63600-2, and 63600-1, including display and keypads.
Describes rear panel connectors on mainframes, including ports, sockets, and fan holes.
Explains local control via front panel and remote control via interfaces; how to switch between them.
Lists five operation modes: CC, CR, CV, CP, CZ, and explains mode changing and parameter programming.
Explains dynamic load modes (normal and frequency sweep), programming of levels, durations, slew rates, and repeat times.
Explains CR mode operation where current is proportional to input voltage, and calculation of resistance.
Explains CV mode operation where load sinks current to control voltage source.
Explains CP mode operation where load sinks current according to programmed power.
Explains CZ mode operation where load sinks current according to programmed impedance.
Describes saving and recalling settings for various test setups.
Details mainframe front panel keys (Spec, Lock, Save, Recall, Local) and indicators.
Describes front panel keys and connectors for single and dual channel load modules.
Guides on setting configuration parameters like Von point, Current limit, All run, for initial setup.
Covers CC, CV, CP, and Dynamic/Slew Rate performance tests.
To Next Page