Local Operation
4.6.7 User Defined Waveform
[ ADVANCE ]
1.TIMING
2.SINE WAVE DYNA
3.OCP TEST
4.AUTO SEQUENCES
[ ADVANCE ]
5. MPP TRACKER
6. USER DEF. WAVE
4.7 Setting the Configuration
The Electronic Load provides useful features such as Von point, Current limit, All run, etc. To
use these powerful features, you must set relevant parameters in accordance with
application needs for configuration setup. This procedure is needed for initial setup only. The
configuration of each channel is stored separately in the EEPROM of Mainframe. To set
configuration you need to press and simultaneously to enter into the page of
system configuration, the VFD displays the Configuration Setting.
[ C O N F I G U R E ]
1. SETUP
2. GO / NG SPEC.
3. REMOTE
4. PARALLEL MODE
[ C O N F I G U R E ]
5. SYNC. DYNAMIC
6. CALIBRATION
7. DEFAULT
8. INFORMATION
[ C O N F I G U R E ]
9. DIGITIZING
To Next Page
Loading...
Need help?
General
