Programmable DC Electronic Load 63600 Series Operation & Programming Manual
4. Set Slew Rate
The VFD displays:
Turn the Rotary knob to change the display value to 1.000A/μs, then press key
to confirm. The slew rate settings change to fall at the same time.
The VFD displays:
Turn the Rotary knob to change the display value to 1.000A/μs, then press key
to confirm. At the same time it changes to setting Repeat times.
Full scale range of slew rate switches automatically among low, middle and high.
5. Set Repeat times
The VFD displays:
Turn the Rotary knob to change the display value to 0 times, then press key to
confirm. Then the display will go to the first editing page again.
6. Review and update the values of the setting parameters
Review the values of the setting parameters by pressing key. Update them by
set new value in their setting pages.
After completion of the data edit, key must be pressed. Otherwise, pressing the
key, new data will not be written into the internal memory, the previous value for
the parameter is kept.
7. Quit from editing mode
Press to quit from editing mode. Then, the VFD display will go back to the
voltage, current, and peak plus/minus voltage measurement display mode.
4.5.4 Setting Dynamic Load Frequency Sweep Values
When operate in CC Dynamic load frequency sweep mode, the VFD displays CC Dynamic
load frequency sweep mode.
0 . 0 0 0 0 mV
0 . 0 0 0 0 mA
0 . 0 0 0 0 mW
To Next Page
Loading...
Need help?
General
