Ensure that your vehicle is parked outside of the
garage before you begin programming.
It is recommended that you erase all the channels of
your HomeLink before you use it for the first time.
If you have any problems, or require assistance,
please call toll-free 1-800-355-3515 or, on the Inter-
net at HomeLink.com for information or assistance.
Erasing All The HomeLink Channels
To erase the channels, follow this procedure:
1. Place the ignition switch into the ON/RUN
position.
2. Push and hold the two outside HomeLink but-
tons (I and III) for up to 20 seconds, or until the
HomeLink indicator light flashes.
NOTE:
Erasing all channels should only be performed when
programming HomeLink for the first time. Do not
erase channels when programming additional but-
tons.
Identifying Whether You Have A
Rolling Code Or Non-Rolling Code
Device
Before programming a device to one of your
HomeLink buttons, you must determine whether
the device has a rolling code or non-rolling code.
Rolling Code Devices
To determine if your device has a rolling code, a
good indicator is its manufacturing date. Typically,
devices manufactured after 1995 have rolling codes.
A device with a rolling code will also have a
“LEARN” or “TRAIN” button located where the
antenna is attached to the device. The button may
not be immediately visible when looking at the de-
vice. The name and color of the button may vary
slightly by manufacturer.
NOTE:
The “LEARN” or “TRAIN” button is not the button
you normally use to operate the device.
Non-rolling Code Devices
Most devices manufactured before 1995 will not
have a rolling code. These devices will also not have
a “LEARN” or “TRAIN” button.
Programming HomeLink To A Garage
Door Opener
To program any of the HomeLink buttons to acti-
vate your garage door opener motor, follow the
steps below:
NOTE:
All HomeLink buttons are programmed using this
procedure. You do not need to erase all channels
when programming additional buttons.
1. Place the ignition switch into the ON/RUN
position.
2. Place the garage door opener transmitter 1 to
3 inches (3 to 8 cm) away from the HomeLink
button you wish to program, while keeping the
HomeLink indicator light in view.
3. Push and hold the HomeLink button you want to
program while you push and hold the garage
door opener transmitter button you are trying to
replicate.
4. Continue to hold both buttons and observe the
HomeLink indicator light. The HomeLink indi-
cator light will flash slowly and then rapidly.
Once this happens, release both buttons.
GETTING TO KNOW YOUR VEHICLE
70
To Next Page
